Side Broom Maintenance - Nilfisk SR 1601 D3 Betriebsanleitung

SIDE BROOM MAINTENANCE

Side broom adjustment
NOTE
Brooms of various hardness are available.
This procedure is applicable to all types of brooms.
1. Drive the machine on a level fl oor.
2. Engage the parking brake.
3. Turn the ignition key (64) and start the machine.
4. Lower the side broom with the lever (52) and let it run for 1 minute.
5. When lowered, the side brooms (9) (15, equipped on SR 1601 MAXI) should be contacting the fl oor as shown in the fi gure (A
and B, Fig. 4).
6. To adjust, loosen the knob (A, Fig. 5) and operate on the side broom adjuster (B) by considering the following:
• When turning clockwise, the side broom pressure is decreased.
• When turning counter-clockwise, the side broom pressure is increased.
After adjusting, lock the adjuster with the knob (A).
7. Repeat steps 1-5 to check the proper adjustment of the side broom height.
8. When the broom is too worn out the adjustment is no more possible; replace the broom according to the instructions in the
next paragraph.
NOTE
The side brooms (9) (15, equipped on SR 1601 MAXI) should be replaced when the bristles are worn to a length of 3 in
(75 mm). When replacing the side brooms, adjust the height.
B
Figure 4
SR 1601 D3 / LPG3 / P3
USER MANUAL
A
A
P100323
33019216(2)2009-05 A
ENGLISH
B
Figure 5
25
P100324