Dell PowerVault 725N Aktuelle Informationen Seite 8

2X008ebk0.book Page 6 Friday, July 11, 2003 1:38 PM
1-6
Infor m ation Update
Downloaded from www.Manualslib.com
Insert the CERC card firmly into the expansion-card connector on the riser board
12
until the card is fully seated, being careful not to disconnect the riser board from the
system board. See Figure 1-6.
F i g u r e 1 - 6 . I n s t a l l i n g t h e C E R C C a r d
CERC card
expansion-card connector
(on riser board)
system board
Place the bottom edge of the cable into the guide slot directly under the connector on
13
the left side of the backplane (as viewed from the front of the system), and then attach
the cable to the connector on the backplane. See Figure 1-5.
Replace the plastic insert adjacent to the expansion slots. See Figure 1-4.
14
Align the blower assembly and fan assembly with the connectors on the system board
15
and the pegs on the chassis.
Push down on the blower assembly and fan assembly until they are properly seated on
16
the chassis pegs.
manuals search engine
PCI slot 1