Connecting A Microphone; Connecting An Instrument; Inserting A Label; Before The Soundcheck - AKG WMS 40 FLEXX Bedienungsanleitung

3.7.1 Connecting a
Refer to fig. 10
Also refer to section 4
Microphone Technique.
3.7.2 Connecting an
Refer to fig. 10

3.7.3 Inserting a Label

Refer to fig. 4 on page 2.
3.8 Before the
30
Downloaded from www.Manualslib.com
3 Setting Up
A 4-V positive supply voltage for condenser microphones is available on
pin 3.
Important! Please note that AKG cannot guarantee that the PT 40 FLEXX body-
pack transmitter will work perfectly with products from other man-
ufacturers and any damage that may result from such use is not cov-
ered by the AKG warranty scheme.
1. Set the frequency selector (25) on the transmitter and the frequency
Microphone selector (8) on the receiver to the same positions (1 - 1, 2 - 2, or 3 - 3).
2. Remove the battery compartment lid (28).
on page 3. 3. Plug the mini XLR connector on the cable of your microphone into the
audio input socket (24) on the bodypack transmitter.
4. Set the on/off switch (22) to "ON" to switch power to the bodypack
transmitter on.
5. Set the SQUELCH control (14) on the receiver to minimum and
switch power to the receiver on.
6. Talk or sing into the microphone.
7. Use the screwdriver (28a) integrated in the battery compartment lid (28)
to set the GAIN control (29) to a position where the AF CLIP LED (6b)
on the receiver will flash occasionally.
8. Replace the battery compartment lid (28) on the transmitter.
1. Set the frequency selector (25) on the transmitter and the frequency
Instrument selector (8) on the receiver to the same positions (1 - 1, 2 - 2, or 3 - 3).
2. Remove the battery compartment lid (28).
on page 3. 3. Plug the jack plug on the MKG L guitar cable into the output jack on
your instrument and the mini XLR connector on the guitar cable into
the audio input socket (24) on the bodypack transmitter.
4. Set the on/off switch (22) to "ON" to switch power to the bodypack
transmitter on.
5. Set the SQUELCH control (14) on the receiver to minimum and
switch power to the receiver on.
6. Play your instrument.
7. Use the screwdriver (28a) integrated in the battery compartment lid (28)
to set the GAIN control (29) to a position where the AF CLIP LED (6b)
on the receiver will flash occasionally.
8. Replace the battery compartment lid (28) on the transmitter.
1. Remove the battery compartment lid (28).
2. Remove a label from the supplied sheet.
3. Letter the label as desired.
4. Remove the battery and place the label on the viewing window (28b).
5. Replace the battery and slide the compartment lid (28) back in place
on the transmitter.
1. Move the transmitter around the area where you will use the system
Soundcheck to check the area for "dead spots", i.e., places where the field strength
seems to drop and reception deteriorates.
If you find any dead spots, try to eliminate them by repositioning the
receiver. If this does not help, avoid the dead spots.
2. The RF OK LED (3a) on the receiver going out means no signal is be-
ing received or the squelch is active.
Switch the transmitter on, move closer to the receiver, or set the squelch
threshold to the point that the green RF OK LED (3a) will be lit.
manuals search engine
WMS 40 FLEXX