Troubleshooting - AKG WMS 40 FLEXX Bedienungsanleitung

Noise, crackling,
unwanted signals.
Momentary loss of sound
("dropouts") at some locati-
ons within performance area.
34
Downloaded from www.Manualslib.com

6 Troubleshooting

Problem
1. AC adapter is not con-
2. Receiver is OFF.
3. Receiver is not connected
4. VOLUME control on recei-
5. Microphone or instrument is
6. Transmitter is tuned to diffe-
No sound. 7. Transmitter on/off switch is
8. Transmitter batteries are not
9. Transmitter batteries dead.
10.Transmitter is too far away
11.Obstructions between
12.Receiver is invisible from
13.Receiver is too close to me-
1. Antenna location.
2. Interference from other wi-
1. GAIN control is set too high
Distortion.
2. Interference from other wi-
• Antenna location.
manuals search engine
Possible Cause
nected to receiver and/or
power outlet.
to mixer or amplifier.
ver is at zero.
not connected to bodypack
transmitter.
rent frequency than receiver.
at "OFF" or "MUTE".
inserted properly.
from receiver or squelch
threshold setting is too
high.
transmitter and receiver.
transmitter location.
tal objects.
reless systems, TV, radio,
CB radios, or defective
electrical appliances or in-
stallations.
or too low.
reless systems, TV, radio,
CB radios, or defective
electrical appliances or in-
stallations.
Remedy
1. Connect AC adapter to re-
ceiver and/or power outlet.
2. Push ON/OFF switch to
switch receiver ON.
3. Connect receiver output to
mixer or amplifier input.
4. Turn up VOLUME control.
5. Connect microphone or in-
strument to audio input on
bodypack.
6. Tune transmitter and recei-
ver to same frequency.
7. Set transmitter on/off switch
to "ON".
8. Insert batteries conforming
to "+" and "-" marks.
9. Replace batteries.
10.Move closer to receiver or
reduce squelch threshold
setting.
11.Remove obstructions.
12.Avoid spots where you can-
not see receiver.
13.Move receiver away from or
remove interfering objects.
1. Relocate receiver.
2. Switch off interference sour-
ces or defective appliances,
or switch WMS 40 FLEXX to
different frequency; have
electrical installation
checked.
1. Handheld transmitter: Set
GAIN to alternative position.
Bodypack transmitter: Turn
GAIN control down or up
just enough to stop the dis-
tortion.
2. Switch off interference sour-
ces or defective appliances,
or switch WMS 40 FLEXX to
different frequency; have
electrical installation
checked.
• Relocate receiver. If dead
spots persist, mark and
avoid them.
WMS 40 FLEXX