Commissioning; Insert Batteries Into The Transmitter; Connecting The Antennas - AKG DMS800 Bedienungsanleitung

commissioning

DMS800 MANUAL
6 Commissioning
Before commissioning your DMS800, check that the transmitter and receiver
are set to the same frequency.
To commission the DMS800, proceed as follows:
1.

Insert batteries into the transmitter

2. Connect the antennas
3. Position the receiver
4. Connect the receiver to the mixing console/amplifier
5. Reposition the GROUND LIFT switch (optional)
6. Connect the receiver to the power network
6.1 Insert batteries into the transmitter
Step Description
1 Open the battery compartment cover (9)
2 Insert batteries into the battery compartment.
When inserting the batteries, note the symbols in the battery
compartment to ensure the power supply.
3 Close the battery compartment cover (9)
6.2

Connecting the antennas

The following antennas can be mounted on the receiver:
λ/4 antennas (included as standard)
•
For all applications where there is a line of sight between the trans‑
mitter and receiver antennas.
Remote antennas
•
For applications where the reception conditions are not optimal at
the receiver position.
77