Rear Panel Controls; Ht 40 Flexx Handheld Transmitter - AKG WMS 40 FLEXX Bedienungsanleitung

5 Color code: The color indicates the carrier frequency band of the re-
ceiver. Transmitters and receivers tuned to the same frequency band
are marked with the same color. Refer to the Manual Supplement sheet
for a color code table.
6 AF LEDs: Indicate the received audio level:
6a OK (green): -30 dB to +3 dB
6b CLIP (red): >3 dB. This LED illuminates to indicate the audio level
of the received signal is overloading the receiver's audio section.
The green AF OK LED being lit and the red AF CLIP LED flashing
occasionally indicate optimum modulation.
If none of the LEDs is lit, the gain setting on the transmitter is too
low.
7 VOLUME: This rotary control adjusts the receiver's output level from
microphone to line level for matching to the input sensitivity of your
mixer or amplifier. The control range is 26 dB.
8 Frequency selector: This slide switch tunes the receiver to one of three
different carrier frequencies within the receiver's carrier frequency band.
9 Carrier frequency label: A label indicating the name of the carrier fre-
quency band and the three carrier frequencies of your receiver is af-
fixed to the rear panel of the receiver.
10 AUDIO OUT/BALANCED: Balanced 3-pin XLR audio output for con-
necting to, e.g., a microphone input on the mixing console.
11 AUDIO OUT/UNBALANCED: Unbalanced audio output on a 1/4" TS
jack for connecting to, e.g., a guitar amplifier.
12 Strain relief for the feeder cable of the supplied AC adapter.
13 DC ONLY: Input connector for the supplied AC adapter.
14 SQUELCH: The squelch circuit switches the receiver off if the received
signal is too weak, in order to suppress the related noise or the resid-
ual noise of the receiver while the transmitter is off. Set the SQUELCH
control to minimum before first switching the receiver on.
Operating in the 660 MHz to 865 MHz UHF range, the HT 40 FLEXX pro-
vides three selectable, quartz stabilized carrier frequencies within the 3-MHz-
wide frequency band for which you ordered your WMS 40 FLEXX. The an-
tenna is integrated in the body.
The microphone element permanently mounted on the transmitter uses
a high quality cardioid transducer from AKG. It provides low handling noise
sensitivity, high gain before feedback, and brilliant sound quality, as well
as a built-in wind and pop filter to reduce wind and breath noise.
WMS 40 FLEXX
Downloaded from www.Manualslib.com
10 11
manuals search engine
2 Description
12
14 13
2.4.2 Rear Panel
Controls
9
Fig. 2: Rear panel
controls on
SR 40 FLEXX receiver.
2.5 HT 40 FLEXX
Handheld Transmitter
25