Controls; Pt 40 Flexx Bodypack Transmitter - AKG WMS 40 FLEXX Bedienungsanleitung

2.5.1 Controls

Refer to fig. 3 on page 2.
2.6 PT 40 FLEXX
Bodypack Transmitter
2.6.1 Controls
Refer to fig. 4 on page 2.
26
Downloaded from www.Manualslib.com
2 Description
15 On/off switch: This slide switch provides three positions:
ON: Power to the transmitter is on.
MUTE: The signal delivered by the microphone element is muted while
power and the RF carrier frequency remain on.
OFF: Power to the transmitter is off.
16 Status LED: Indicates the transmitter's operating status.
LED lit green: Battery is OK.
LED lit red: From the moment the LED changes to red, the battery ca-
pacity will provide a maximum of two operating hours. We recommend
replacing the battery with a new one as soon as possible.
Note: If you use a rechargeable battery, the LED will change to red 15 min-
utes before the battery will be dead!
17 Frequency selector: This slide switch tunes the transmitter to one of
three different carrier frequencies within the transmitter's carrier fre-
quency band.
18 GAIN: This slide switch sets the transmitter's audio input gain in two
stages, "HIGH" (high gain) or "LOW" (low gain).
19 Color code clip: The color of this plastic clip indicates the carrier fre-
quency band of your transmitter. Receivers tuned to the same frequency
band are marked with the same color. Refer to the Manual Supplement
sheet for a color code table.
You can remove the color code clip on the HT 40 FLEXX and replace
it with the supplied semitransparent clip.
20 Battery compartment lid: Refer to section 3.5.
21 Carrier frequency label: The label above the battery compartment in-
dicates the name of the carrier frequency band and the three carrier
frequencies of your transmitter.
You can use the PT 40 FLEXX bodypack transmitter with both dynamic
microphones and condenser microphones operating on a supply voltage
of approx. 4 V. You may also connect an electric guitar, electric bass, or
remote keyboard.
Operating in the 660 MHz to 865 MHz UHF range, the HT 40 FLEXX pro-
vides three selectable, quartz stabilized carrier frequencies within the 3-MHz-
wide frequency band for which you ordered your WMS 40 FLEXX.
22 On/off switch: This slide switch provides three positions:
ON: Power to the transmitter is on.
MUTE: The signal delivered by the microphone element is muted while
power and the RF carrier frequency remain on.
OFF: Power to the transmitter is off.
23 Status LED: Indicates the transmitter's operating status.
LED lit green: Battery is OK.
LED lit red: From the moment the LED changes to red, the battery ca-
pacity will provide a maximum of two operating hours. We recommend
replacing the battery with a new one as soon as possible.
Note: If you use a rechargeable battery, the LED will change to red 15 min-
utes before the battery will be dead!
manuals search engine
WMS 40 FLEXX