Battery And Charger - SoFlow SO4 Originalbetriebsanleitung

Instructions on adjusting the dics brake
If the brakes are too tight, use a 5mm Allen wrench to loosen the screw of the pressure plate by turning anticlockwise. Shorten the length of the brake wire to loosen the brakes, then
tighten the screw again. If the brakes are too loose, loosen the screw and pull the brake wire to extend the wire, then tighten the screw again.
Inflating the tyres
In case that the tyres start lose pressure, you should inflate them to the recommended pressure.
3.3 Mobile phone holder
Your SO4 / SO4 PRO comes with a mobile phone holder which can be easily attached or detached. Simply wrap the strap around the handlebar, pull it through the buckle and make sure
it is firmly secured. You can pull around the mount to check if your mobile phone is firmly held in place. The stretchable silicon bands can hold all smartphones with a screen size from 4
to 6.2 inches.
WARNING!

3.4 Battery and charger

The range of the battery may differ from the specifications depending on the temperature, the condition of the track, the incline and the weight of the driver.
Charging the battery
Make sure that the charging connector and the charger are dry and that the SO4 / SO4 PRO is switched off. Connect the charger cable to the scooter's charging connector and plug it into
an electrical outlet. The charging light on the charger should glow red. When the charging light changes from red to green, the battery is fully charged. Disconnect the charger from the
power source and the scooter.
The e-scooter should only be charged with the original charger. Ensure that the voltage supply is correct. Do not use the charger if the charger or power cable are damaged. Please contact
the service department. For optimum battery life, charge and store the e-scooter in a dry and clean environment, preferably room temperature. The charging time of the scooter is
approximately 4 – 5 hours. There will be negative effects on the battery life if the charger remains permanently connected to the scooter and the power source.
Battery handling
Do not cover the scooter or the charger during charging. Lithium batteries have different freezing points depending on their charge level. If a battery cell freezes, it is irreparably destroyed
and the entire battery must be replaced. As with conventional batteries, a lithium battery loses up to 40% of its capacity starting from approximately 0°C.
Correct handling of the battery
Never remove the battery from the scooter. Charge the battery for at least 1 hour every month (even when not in use). Never heat the battery or expose it to open fire. Never dispose of
the battery cells together with general waste. Never bring battery contacts into contact with moisture. The ideal operating temperature of the battery is between 10°C and 30°C. Above
as well as below this temperature, the power output deteriorates, resulting in a reduced range and power output.
The life and performance of a battery depends on its age, care and how often it has been used. Compared to other battery models, lithium ion batteries have very low self-discharge and
a very low memory effect, but they need to be charged periodically. Even if you do not use your scooter, the battery must be charged for at least 1 hour every month, otherwise it will
lose capacity. Regular charging will prevent the battery from total discharge. Please note that an excessively discharged battery is irreparably damaged and must be replaced for a fee,
hence the battery should never be completely discharged during operation.
copyright by www.soflow.com 12