15.9 Reset to factory settings
Press
and
the factory setting and your individual settings for the amount of water and milk foam are
deleted.
15.10
Change the mode
You can set the device to different mode. The different mode are as follows:
Function/mode
Selected mode can be
recognized as follows
Illumination
Prebrewing*
Saving of filling level
Automatic switching off
* Pre-brewing: With less water pressure, the ground coffee is moistened and pre-brewed.
Then the device brews with normal water pressure and prepares the coffee.
Press
button for 5 seconds then the
already selected (look at the table). Press the respective button for the switch to the
selected mode. For Example when switching to the Eco mode press the
Two signal tones sound. If the mode should be retained then press
seconds.
16 Cleaning and Maintenance
This chapter provides you with important notices with regard to cleaning and maintaining
the device. Please observe the notices to prevent damages due to cleaning the device
incorrectly and to ensure trouble-free operation.
and hold for 5 seconds, until the device beeps twice. This resets
ECO (energy-saving
mode)
Button
lights
continously and the
others are flashing
-
+
+
After 10 minutes
Fast
Button
lights continously
and the others are
flashing
+
-
+
After 30 minutes
will flash and you can see which mode is
Standard
Button
lights continously
and the others are
flashing
+
+
+
After 20 minutes
button.
or wait 5
69