Menu Channel Settings - Team Electronic HAM MobileCom 1011 Bedienungsanleitung

To open the menu channel settings, press the key【MENU】(5) shortly. The symbol F (1) appears in the upper left
corner of the LCD. Press the channel selector [PUSH] (14) to open the menu.
To open the menu general settings, press the key【MENU】(5) approximately 2 seconds.
Once the menu is activated, use the rotary channel selector (14) to select a function. To edit the setting for the selected
function, press the channel selector [PUSH] (14). Make your selection by turning the rotary channel selector and press it to
confirm your selection. To exit the menu press any key.
[SCAN] channel scanning
1. Start channel scanning by pressing the key【SCAN】(6). The symbol SC (4), located in the lower left corner, starts blinking.
2. Change the direction of the scanning (Up / Down) by turning the rotary channel selector.
3. To stop the channel scanning press the key【SCAN】(6) again.
add to/delete from scan list
In channel mode, only the channels of the scan list will be scanned. Channels that are added to the scan list can be re-
cognized by the letter SC (4) in the lower, left corner. To add a channel to the scan list (or delete it), hold the key
【SCAN】(6) for approximately 2 seconds. The scan list can also be edited via the menu channel settings.
[DW] Dual-Watch On/Off
Pressing shortly the key【DW】(7), will activate the dual watch function. Once activated, the symbol DW (10) appears.
Setup Dual Watch function
1. Select the first channel for the dual watch function.
2. Hold the key【DW】(10) for appr. 2 seconds until the symbol DW starts blinking.
3. Now, set the second channel for the dual watch function and press again the key【DW】(10) for confirmation.
[EMG]
priority channels 9/19 and key lock
priority channel 9/19: The tri-state key【EMG】(15) switches from priority channel 9 to priority channel 19 and then back to
regular mode. The priority channels 9 and 19 are indicated by the symbol EMG (15).
key lock: To activate the key lock function, which deactivates all keys except for the PTT key, hold the key【EMG】(15)
for approximately 2 seconds until the key symbol (17) appears.
30

MENU CHANNEL SETTINGS

1. To open the menu channel settings, first, press the key【MENU】(5) shortly (the symbol F (1) will appear) and then,
press the channel selector【PUSH】(14).
2. Make your selection by turning the rotary channel selector (14).
3. Press the channel selector【PUSH】(14) to access the available settings.
4. Now, make your selection by turning the rotary channel selector (14) and confirm your selection by pressing the
channel selector【PUSH】(14).
5. To exit the menu, press the key【MENU】(5) or any other key.
No. Function LCD Symbol settings and description
1 BUSY transmission blockage on occupied channels; ON/OFF
2 REP direction of TX REP frequency shift
OFF : no shift
REP+ : shift to top
REP- : shift to bottom
8 SCAN SC edit scan list; symbol SC (14)
ADD / DEL
4 Public Data PD general settings; ON / OFF; activates / deactivates
Menu Channel settings in active state, these functions
are not available: HICUT, NB, ECHO, 10KHZ and
ROGER
5 HI-CUT HIC receiving tone type; ON / OFF
6 NB NB Noise Blanker; ON / OFF
7 ECHO ECHO Echo; ON / OFF
31