Operation; Function Keys - Team Electronic HAM MobileCom 1011 Bedienungsanleitung

On/Off
1. To switch on the HAM MobileCom 1011, turn the volume control (13) clockwise, over the contact barrier. An acoustic
signal is emitted and the LCD lights up.
2. To switch off the radio, turn the volume control (13) counterclockwise over the contact barrier.
Volume
Turning the volume control (13) will adjust the volume level. The LCD will then display the actual volume level (1-36).
TX Power
For the adjustment of the tx power use the power control (9). The maximum tx power of the selected frequency band (AM /
FM / SSB) is set by turning the power control clockwise all the way to the end.
RF Gain
For the adjustment of the receiver sensitivity use the RF-Gain control (10). If received signals are distorted due to imme-
diate proximity to the transmitter, the receiver sensitiviy can be reduced with the RF Gain function.
SQUELCH
For the adjustment of the squelch level use the squelch control (11). During adjustment, the symbol SQ and the actual
level (1-36) are displayed.
SSB Clarifier
For fine tuning of the transmitter and receiver frequencies for USB / LSB, use the SSB Clarifier control (12).
Channel Selection
Use the rotary channel selector control (14) for channel selection.
Please note: for a manual entry of the frequency, push the rotary channel selector [PUSH] (14). The fourth digit starts blin-
king. Set the value by turning the channel selector and push it to confirm the entry and to proceed to the next digit. Conti-
nue repeating these steps until all entries have been made.
28

OPERATION

[MEM]
MEMORY CHANNELS M1-M6:
To enter or quit the memory channel mode, press the key【MEM】(1). The letter M (21) to the right of the frequency or
the memory channel number indicates the active status of the memory channel mode.
In channel mode the display reads ME--M(1-6). In frequency mode, the frequency of the selected memory channel is dis-
played. Use the key【FRQ】(4) to switch between the channel mode and the frequency mode. The selected frequency
band (A-I) is shown on the top of the LCD (13).
save a memory channel:
To save a channel as a memory channel, exit memory channel mode first.
Then, select the frequency and hold the key【MEM】until the memory channel mode is activated. The letter M and ME--
M(1-6), with M(1-6) blinking, will appear. Now, select the memory channel number where the frequency should be saved
and hold the key【MEM】until M(1-6) stops blinking.
[MODE]
To switch between the operating modes FM-AM-USB-LSB, press the control【MODE】(2). The actual operating mode is
shown in the upper left LCD (5).
[BAND]
To switch between the frequency bands A-B-C-D-E-F-G-H-I-J, press the control【BAND】(3). The actual frequency band is
shown in the upper left LCD (13).
[FRQ]
Use the control【FRQ】(4) to switch between frequency and channel mode.
[MENU]
All functions and settings of the HAM MobileCom 1011 are organized in three different menus.
The menus channel settings (PD, HICUT, NB, ECHO, +10kHz, ROGER, BUSY, SCAN) and general settings (BEEP,
INDIC, MIC, NOG, TOT, TSR, TDC, SCAN, FIN, COLOR, RESET) are activated with the control [MENU] (5).

FUNCTION KEYS

29