Opening and
Opening the Device:
Closing the De-
vice
(2)
(4)
(4)
(4)
42
(1)
(3)
1
(1)
Set the DC disconnector (1) to the 0
1
position
Loosen 4 screws 5x25 TX25 (2) and
(2)
2
remove Datcom lid
If applicable, disconnect all plug
3
connections
Loosen 2 screws 5x25 TX25 (3)
4
(3)
2
Lift the inverter in the Datcom area and
5
loosen the connection to the mounting
bracket
Detach the inverter from above
6
Remove EMC bracket, loosen 6
7
screws 5x16 TX25 (4) and remove po-
wer stage set lid
(4)
(4)
(4)
WARNING! Observe the safety
rules (see the beginning of the
"Safety" section)
NOTE! To avoid damage to the
base shell, the inverter must not
exceed an angle of 11°.
WARNING! Wait for the capacitor
discharge time before carrying out
further steps.