Safety Information - FLORABEST 9925902 Montage-Und Sicherheitshinweise

Safety information

ATTENTION! READ ASSEMBLY- AND OPERAT-
ING INSTRUCTIONS BEFORE USE!
KEEP THE ASSEMBLY AND OPERATING IN-
STRUCTIONS IN A SAFE PLACE!
KEEP OUT OF THE REACH OF
CHILDREN. THIS PRODUCT IS
NOT A TOY! INJURIES MAY
OTHERWISE OCCUR!
This hose is designed for tap water.
Do not drink water from this hose.
Otherwise there is a risk of injury.
Be sure water from the hose cannot return to
the drinking water supply: Disconnect the hose
from the tap after use, or install a backflow pre-
venter or pipe interrupter between the tap and
hose.
Never leave the hose unsupervised – even if
the water flow is temporarily interrupted. Oth-
erwise injuries or property damage may occur.
Do not subject the hose to
frost. Otherwise property
damage may occur.
Ensure particles of dirt do not plug the connec-
tors or enter the hose. The fittings may otherwise
be damaged.
Do not aim the water jet at electrical equip-
ment.
Do not aim the water jet at persons or animals.
Assembly
You will need:
Cross-tip screwdriver (PH2)
Power drill, drill bit ø 6 mm
Important! Please refer to the operating instruc-
tions of your power drill.
Ensure that you do not damage any electrical cables,
gas or water pipes when you drill into the wall.
12 GB
Installing the hose holder
Install the hose holder
Use the included screws
These are only suitable when mounting to brick,
concrete- or wooden walls. Please use suitable
screws and rawlplugs when mounting to other
materials. Consult your retailer for rawlplugs
and screws suitable for the respective wall.
Note: To prevent backflow, do not mount the
hose holder higher than the tap, or install a
7
backflow preventer or stop cock between the
tap and hose .
6
Use
Connecting
Connect the hose
6
Using the spray nozzle
Note: the spray nozzle
spray patterns. The flow rate is variable.
Insert the spray nozzle
tor with water stop
Move the trigger switch
water flow and for variable adjustment (cf.
Fig. D).
Turn the wheel to position „ ", to select or
1b
adjust the spray pattern (cf. Fig. D).
Move the trigger switch
water flow (cf. Fig. D).
Note: When removing the spray nozzle
the tap on, the hose connector with water stop
will interrupt the water flow.
Only use this option for interrupting the water flow
when connecting a different item to the hose, e.g. a
water sprinkler.
ATTENTION! Only use the options for interrupt-
ing the water flow described in this chapter to stop
the flow temporarily! To stop the water flow for a
longer period, close the tap.
is shown in Figure A.
7
and rawlplugs
4
as shown in Figure B.
features ten different
1
in the hose connec-
1
(cf. Fig. C).
3
to the back to start
1a
forward to stop the
1a
with
1
.
5
3
®