Electrolux WA 1457 F Benutzerinformation Seite 7

D • The programme time
When the programme starts, the time decreases with steps of 1 minute.
• The delay start
When you press the delay start button, the display shows the delay start time.
• Alarm codes
If the appliance has a malfunction, the display shows alarm codes. Refer to 'Troubleshoot-
ing' chapter.
• Err
The display shows this message for some seconds if:
– You set a function that is not applicable for the programme.
– You change the programme while it operates.
The indicator of the Start/Pause button
•
When the programme is completed.
1) Only available for Spin/Drain programme.
2) The symbols appear on the display when the related phase or function is set.
START/PAUSE BUTTON
Press button
gramme.
DELAY START BUTTON
Press button
gramme from 30 minutes to 20 hours.
TIME SAVE BUTTON
Press the button
gramme duration.
• Press one time to set 'Shortened dura-
tion' for items with daily soil.
• Press two times to set 'Extra Quick' for
items with almost no soil.
Some programmes accept only one of
the two functions.
EXTRA RINSE BUTTON
Press button
programme.
Use this function for persons allergic to de-
tergents and in areas where the water is
soft.
STAIN BUTTON
Press button
programme.
Use this function for laundry with hard
stains to remove.
When you set this function, put the stain re-
mover into compartment
Downloaded from www.Manualslib.com
4
4
to start or interrupt a pro-
5
5 to delay the start of a pro-
6
6
to decrease the pro-
7
7
to add rinsing phases to a
8
8
to add the stain phase to a
.
manuals search engine
4
flashes.
This function increases the programme
duration.
This function is not available with a
temperature lower than 40° C.
9
SPIN BUTTON
Press this button to:
• Decrease the maximum speed of the
spin phase when you set a programme.
The display shows only the spin
speeds available with the set pro-
gramme.
• Deactivate the spin phase.
• Activate the 'Rinse Hold' function. Set
this function to prevent fabric creases.
The appliance does not drain the water
when the programme is completed.
Spin phase is off.
'Rinse Hold' function is on.
TEMPERATURE BUTTON
10
Press button to change the default tem-
perature.
- - = cold water
ACOUSTIC SIGNALS FUNCTION
You can hear the acoustic signals when:
• You activate the appliance.
• You deactivate the appliance.
• You press the buttons.
• The programme is completed.
• The appliance has a malfunction.
electrolux 7
10