Operation - Meister MAS18MZ Originalbetriebsanleitung

CAUTION! Only use the sup­
plied charger to charge the
rechargeable battery (12).
CAUTION! Check the
voltage specifications of the
charger (12) with the voltage of
your mains power supply before
plugging the charger in.
1. Plug the charger (12) into the
socket. The charging status check
light (13) on the charger (12) lights
up in green and signals when
ready to operate.
2. Slide the rechargeable battery
through the charging cradle (14)
over the contacts of the
charger (12) until it clicks audibly
into place. During the charging
process, the charging status
check light (13) on the charger
turns to red.
3. The charging process should take
about­60­minutes.­It­is­finished­as­
soon as the red LED goes out and
the green LED lights up.
4. Press the unlocking button (8) on
the rechargeable battery and
remove the rechargeable battery
from the charger.
CAUTION! The rechargeable
battery is to be removed from
the charger after the charging time
is complete. A constant warming of
the charger and the battery is nor­
mal and is not a fault.
Battery pack charge monitoring
(Figure 4)
To monitor the charge state, the
battery capacity status display (5)
66
lights up during operation.
MW-5451340-Bedien-1908.indd 66
The charge state is shown as fol­
lows:
•­ Green/Yellow/Red:
The rechargeable battery is fully
charged.
•­ Yellow/Red:
The rechargeable battery is par­
tially discharged.
•­ Red:
The rechargeable battery must be
charged.
9 – Operation
Torque pre­selection
The cordless drill/screwdriver has a
torque setting function with 25+1 lev­
els which helps to avoid damage to
the screw or drill head. By rotating the
torque setting (2) on your cordless
drill/screwdriver, you can select the
required level, from 1 (easy screw­
driver action) through to maximum
(heavy­duty screwdriver/ drilling
action). Always select the most appro­
priate torque for the job in hand.
Do not use the drill setting for
screwdriver work.
Tensioning a tool
Traditional screwdriver bits, bit
holder and drills up to a diameter of
10 mm can be used in the chuck (1).
Only use a tool that can be clamped
securely in the chuck and which is
designed for use with this machine.
See­„Technical­data".
The machine has a quick­action
chuck (1). This allows you to change
12.09.19 08:44