Maintenance And Cleaning; Potability Of Mains Water - Miomare HG04894 Montage-, Bedienungs- Und Sicherheitshinweise

CAUTION! Do not take the screw completely
out; just loosen it until the control lever
be easily taken off.
Take off the control lever
Loosen the cartridge end ring
Then, screw off the cartridge locking ring
by using a pipe wrench.
Now pull the setting ring
help of a screwdriver.
Note: Do not remove the cartridge
Place the setting ring
15
(see Fig. E).
Note: The setting ring
angle of the handle, so that the amount of hot
water can be limited.
Tighten the cartridge locking ring
tap body again by using a pipe wrench.
14
Then, tighten the cartridge end ring
hand.
Place the control lever
body . Tighten the locking screw
14
ing it clockwise using the Hexagonal key
Press the plastic cover
10
Turn on the main water supply and check the
temperature limiter.

Maintenance and cleaning

Tap care and cleaning
Please note that sanitary fittings require special
care and attention. Therefore you should follow
the following advice:
Never use corrosive or alcohol-based materials
for cleaning, as these could damage the product.
Clean your fittings with clean water, mild deter-
gent and a soft cloth or leather only.
Screw out the mixer nozzle
intervals and remove lime deposits or foreign
bodies.
Non-observance of the above care advice can
be expected to result in damage to the surface
of the fittings. In this event your rights under the
warranty may be invalidated.
can
8
.
8
by hand.
11
12
upwards with the
15
.
13
in the desired position
can limit the turning
15
onto the
12
by
11
back on to the tap
8
by turn-
9
.
16
into the opening.
at regular
7
Disposal
The packaging is wholly composed of environmen-
tally friendly materials that can be disposed of at a
local recycling centre.
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out product.
Information

Potability of mains water

Find out about the potability of your mains
water supply. Your local water authority or
water supply company will be able to inform
you.
The following general recommendations
apply to the potability of the water from
your pipework:
Let the water run freely for a short time if it has
been stagnating in the pipework for more than
four hours. Do not use any of this stagnant water
in the preparation of food or for drinking. This
applies particularly as far as babies and infants
are concerned. Failure to observe this advice
may result in risks to health. Fresh water can
be readily distinguished from stagnant as fresh
water is noticeably cooler.
Do not use stagnant water from chromium-plated
pipework for the preparation of food or for drink-
ing or for personal hygiene if you are allergic
to nickel. This water may contain high quantities
of nickel and trigger an allergic reaction.
Do not use water from lead pipework for pre-
paring food or drink for babies or infants. Do
not use it for preparing food or drink during
pregnancy. Lead dissolves in drinking water
and is particularly damaging to the health of
babies and young children.
GB/IE/NI 7