Mounting Or Removing Of The Footrests; Operating The Brakes - Vermeiren V300 DL Gebrauchsanweisung

2.5
2.6
L WARNING:
movements – Use the brake only to prevent the wheelchair from unintended
movements.
L WARNING:
contamination of the tires (water, oil, mud, ...) – Check the condition of the tires
before each use.
L WARNING:
brakes before each use.
Fig. A
To apply the brakes (Fig A):
1.
L CAUTION:
horizontal surface before releasing the brakes. Never release both brakes
simultaneously.
To release the brakes:
1.
2.
3.
Downloaded from www.Manualslib.com

Mounting or removing of the footrests

Operating the brakes

The brakes are not used to slow down the wheelchair during
Good operation of the brakes is influenced by wear and
The brakes are adjustable and can wear – Check the operation of the
Push the brake levers  forward till you feel a distinctive click.
Risk of unintended movement – Make sure the wheelchair is on a flat
Release one brake by pulling the lever  backwards.
Hold the hand-rim of the released wheel with your hand.
Release the second brake by pulling the lever  backwards.
manuals search engine
The mounting of the footrests is done as follows:
1. Hold the footrest sideways at the outside of the
wheelchairs frame and mount the tube hood
into the frame.
2. Swing the footrest inwards till it clicks in
position.
3. Swing the foot plate downwards.
To take off the footrests:

1. Pull lever .
2. Swing the footrest to the outside of the
wheelchair till it comes loose from the guidance.
3. Pull the footrest from tube hood
Fig. B
Page 9
V300DL
2016-03


.
To reduce the braking force
it is possible to extend the
brake lever (Fig B).