Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2
Use
This chapter describes the everyday use. These instructions are for the user and the
specialist dealer.
The wheelchair is delivered fully assembled by your specialist dealer. The instructions
intended for the specialist dealer on how to set up the wheelchair are given in § 3.
2.1
Carrying the wheelchair
The best way to carry the wheelchair is to make use of the wheels and roll the wheelchair.
If this is not possible (e.g. when the rear wheels are taken off for transportation in a car),
firmly grasp the frame on the front and the back. Do not use the foot- or armrests or the
wheels to grasp the wheelchair. At least two persons are required for transporting the
wheelchair.
2.2
Mounting the rear wheels (only for quick release 22", 24" rear
wheels)
2.3
Mounting or removing of the footrests
L
WARNING:
Risk of injury - Make sure that the footrests are firmly locked before
using the footrests.
The wheelchair has two footrests that can be fold away to the "outside" with a 3 point
attachment system (, , on the figure below). This system provides a steady, play-free
connection of the footrest to the seat frame.
1. Take the rear wheel and push on button
2. Keep the button pushed in and mount the rear
wheels axle till it stops.
3. Release the button
4. Check that the wheel is secured.
The mounting of the footrests is done as follows:
1. Hold the footrest sideways at the outside of the
wheelchairs frame and mount the pins into the
holes .
2. Turn the footrest inwards till the pin click in the hole
of the attachment point .
3. Turn the footplates downwards.
To take off the footrests:
1. Fold the footplates upwards.
2. Pull or push on lever .
3. Turn the footrest to the outside of the wheelchair
until the hole comes loose of the pin from
attachment point .
4. Pull the footrest upwards until the pins come out
the holes .
Page 7
Inovys II-F
2016-05
.
.
Werbung
Kapitel
Inhaltsverzeichnis
