Mounting The Rear Wheels; Unfolding The Wheelchair; Mounting Or Removing Of Stabilisator - Vermeiren V300 DL Gebrauchsanweisung

2.2
2.3
L CAUTION:
wheelchair.
1.
2.
3.
4.
5.
2.4
L WARNING:
L WARNING:
stability of the backrest).
The mounting of the stabilisator Ⓑ is done as follows:
1. Mount the stabilisator Ⓑ with the star knob Ⓐ in the left hand grip.
2. Swing the stabilisator Ⓑ to the right.
3. Mount hook Ⓒ over the right hand grip Ⓓ as shown on the drawing. Use holes  or  to
adjust the tension of the backrest.
To take off the stabilisator:
1. Loosen the star knob Ⓐ on the right hand grip.
2. Remove hook Ⓒ from the right hand grip Ⓓ.
Downloaded from www.Manualslib.com

Mounting the rear wheels

Unfolding the wheelchair

Risk of clamping – Keep fingers away from moving parts of the
Position yourself behind the wheelchair.
Use the hand grips to open the wheelchair as much as possible.
Position yourself at the front of the wheelchair.
Push both seating tubes down till they are fixed in their position.
Mount the stabilisator to the right hand grip (standing behind the wheelchair).

Mounting or removing of stabilisator

Risk of injury - Make sure that star knobs Ⓐ are tightened.
Risk of injury - Always mount the stabilisator (→ to increase the
manuals search engine
1. Take the rear wheel and push on button
2. Keep the button pushed in and mount the rear
wheels axle till it stops.
3. Release the button.
4. Check that the wheels are secured.
Page 8
V300DL
2016-03

.