Troubleshooting - Ottobock BionicLink PC 60X5 Gebrauchsanweisung

Caution: Federal law (USA) restricts this device to sale by or on the order of a practitioner
licensed by law of the State in which he/she practices to use or order the use of the device.

9 Troubleshooting

Verify the operational readiness of the 60X5 BionicLink PC using the table below. Eliminate any
possible causes.
Event
The green LED on the 60X5
BionicLink PC is not lit up
The blue LED on the 60X5
BionicLink PC is not lit up
10 Appendix
10.1 Symbols Used
Declaration of conformity according to the applicable European directives
Compliance with the requirements according to "FCC Part 15" (USA)
In some jurisdictions it is not permissible to dispose of these products with unsor­
ted household waste. Disposal that is not in accordance with the regulations of
your country may have a detrimental impact on health and the environment. Please
observe the instructions of your national authority pertaining to return and collec­
tion.
Compliance with the requirements under the "Radiocommunications Act" (AUS)
Lot number
10.2 Technical data
Ambient conditions
Storage and transport in original packaging
Storage and transport without packaging
16
Cause/required action
The 60X5 BionicLink PC is not operational
• Check the connection of the BionicLink on the PC.
• Connect the BionicLink to a different USB port on the PC.
• If a hub is being used, connect the BionicLink directly to
the USB port on the PC.
Connection to component cannot be established or has been
interrupted
• Reduce the distance of the component to the 60X5 Bion­
icLink PC.
• Charge level of the component.
-25 °C/-13 °F to +70 °C/+158 °F
-25°C / -13°F to +70°C / +158°F
max. 93% relative humidity, non-condensing