Troubleshooting; Faults Table - Atag MX4570G Bedienungsanleitung

TROUBLESHOOTING

Faults table

Query
The time counts down but the appliance is
not working (the turntable is not rotating and
food is not heating). "Time" and "Demo" fl ash
alternately in the display.
The appliance does not start.
The appliance continues to make noise after
cooking has ended.
The appliance is noisy.
The turntable does not rotate properly.
You notice steam on the window.
Food is not heated during a microwave
programme.
The grill gives off smoke at the beginning of
a programme.
The appliance produces sparks.
When in doubt about the proper operation of your appliance, this does
not automatically mean there is a defect. Make sure to check the points
mentioned below in the table first, or visit our website 'www.atag.nl' for
more information.
If you suspect that your appliance is not working properly, it may not
necessarily be broken. In all cases, check the following items:
What to do
Your appliance is in DEMONSTRATION mode.
To return to normal mode, set the time to
"00:00" and press the 'TEMPERATURE',
'TIME' and 'STOP' buttons again until
"DEMO" disappears from the display
Check that your appliance is plugged in.
Check that your oven's door is fully closed.
Check that the child safety feature is not
activated.
To drain residual water vapour, your
appliance is equipped with a delayed
ventilation feature.
The fan continues to function for 15 minutes
after the end of the programme.
Clean the wheels and the rolling area under
the turntable.
Check that the wheels are correctly
positioned.
Wipe the condensation off using a cloth.
Ensure that the cookware is suitable for
microwave ovens and that the power level is
appropriate.
Remove all cooking residue from the heating
element before each use.
Thoroughly clean the appliance: remove
grease, cooking residue, etc.
Remove any metal items from the walls of the
oven.
Never use metal items with the rack.
EN 29