Aventics AV03-EP Serie Betriebsanleitung Seite 19

AVENTICS | AV-EP | R414007537–BDL–001–AA | English
AV03-EP
Fig. 2: Position of the material number on the AV-EP base plate
O Please see the catalog sheet or the material short key in the configurator for your
AV-EP pressure regulator configuration.
The material short key for the AV-EP pressure regulator is structured as follows:
AV0X-EP-000-YYY-ZZZ-QQQQ
Table 4: Meaning of the material short key
See
Placeholder Meaning
Fig. 1
AV0X (13) Series
EP (13) Function
000 (8) Min. output pressure 000 = 0 bar
YYY (8) Max. output pressure 060 = 6 bar
ZZZ (9, Set point
15)
1)
QQQQ (7) Version
Display
Defined failure
response to a lack
of UA power supply
to the valves
Output signal
1) Example : CL1P: C = Classic, L = LED, 1 = pressure in the operating line is maintained briefly,
P = actual working pressure value
AV-EP pressure regulator versions
AV-EP pressure regulators for fieldbus connection
AV-EP pressure regulators for fieldbus connection use the AES bus coupler
to communicate within the valve system.
AV03-EP
16
18
Fig. 3: AV-EP pressure regulators for fieldbus connection with display (16, 17)
and without display (18, 19)
AV05-EP
15
Abbreviation
AV03 = AV03 series
AV05 = AV05 series
EP = electropneumatic
pressure regulator
100 = 10 bar
010 = 0–10 V
420 = 4–20 mA
SER = control via fieldbus
C = Classic
S = Smart
L = LED
D = display with integrated LEDs
0 = operating line is exhausted
via the AV-EP
1 = pressure in the operating line
is maintained briefly
P = actual working pressure value
S = switch output
(only with multipole valve systems)
C = 10 V constant
(only with multipole valve systems)
AV05-EP
17
19
AV-EP pressure regulators for multipole connection
AV-EP pressure regulators for multipole connection are actuated via a 5-pin,
A-coded M12 connection.
AV03-EP
20
22
Fig. 4: AV-EP pressure regulators for multipole connection with display (20, 21)
and without display (22, 23)
AV-EP base plate versions
AV-EP base plates are available in different versions. You can use the AV-EP
pressure regulator for pressure zone control or single pressure control depending
on the selected base plate.
W
In AV-EP base plates for pressure zone control, all pneumatic connections
are run through the base plate.
W
On AV-EP base plates for single pressure control, the outlet connection
is on the front side.
AV-EP base plates for fieldbus connection and AV-EP base plates for multipole
connection have different circuit boards. Each AV-EP pressure regulator therefore
requires an AV-EP base plate that corresponds to the control.
AV-EP base plates for fieldbus connection
AV03-EP
24
26
Fig. 5: AV-EP base plates for fieldbus connection for pressure zone control (24, 25)
and single pressure control (26, 27)
AV05-EP
21
23
AV05-EP
25
27
18