Siemens Pointer CLS200 Schnellstartanleitung Seite 16

Delay
• Rise Time (Off to On) determines the delay of the signal flow from the moment the sensor
• Fall Time (On to Off) determines the delay of the signal flow from the moment the sensor
The delay timers have a range of values from 0.0 to 100.0 seconds.
• Go to Input > Transducer Block: Discrete Input > Delay > Rise Time (Off to On) and set the
• Go to Fall Time (On to Off), and set the value from 0 to 100 seconds.
Note:
its initial value and restarted.
Inversion
When Inversion Output = On, the level status undergoes a logical inversion.
• Go to Output > Function Block: Discrete Input > Inversion Output > Off or On
Failsafe Mode
Go to Output > Function Block: Discrete Input > Fail Safe Mode > Fail Safe Mode and select
one of the three options:.
The default value is used as the output
value.
Store the last valid output value.
The calculated output value is incorrect.
Resetting
Open the Device Menu Master Reset and select one of the three options:
Recreates the delivery status. It resets most parameters to the factory setting.
7ML19985XA82
Downloaded from www.Manualslib.com
becomes covered until the Primary Value is set.
becomes uncovered until the Primary Value is reset.
value from 0 to 100 seconds.
If the sensor status changes before the delay interval is complete, the timer is reset to
Failsafe Mode
Factory Reset (restart/cold startup)
Warm start (new start-up)
Disconnects then restarts Pointek CLS200/300. Communication is interrupted and re-
established. Use it if, for example, the PROFIBUS address has been changed.
Resetting the PROFIBUS address to 126
Please see the full manual for details.
Pointek CLS200/300 (Digital) – QUICK START MANUAL
manuals search engine
Description
The predefined preset safety value is output (status code
U_075).
The last valid output value is output (status code U_071).
The bad output value is accompanied by the status which
the Transducer block assigns to it (B_0xx).
Page EN-15