Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Logical level display (output status)
• value when OUT parameter of Discrete
Bar graph
• represents extent to which sensor is covered
• displayed when one of the three following options is selected in Mode 13: the OUT
Setup using 3-button keypad
WARNING: It is essential to check settings during the process itself, and confirm
that they are correct, before regular operation commences.
Notes:
• See Quick Reference table on next page for Modes of Operation.
• Ensure HW Write Protection is disabled (Mode 10, page 8).
Initial setup can be carried out prior to mounting into the process, but it is extremely important
to calibrate the unit and adjust the sensitivity on the product itself.
• Flashing digit indicates cursor position.
• Press M to select a mode. Hold M and tap to move
• To increment or decrement a value, press or .
• To move cursor to the right, press
• After editing the least-significant digit, press to
• To enter a selection (not a numerical value) press M.
Magnet-activated sensor test
Bring the bar magnet supplied close to the test area on the housing. After
approximately 10 seconds, SENSOR TEST SUCCESSFUL, or SENSOR TEST FAILED,
is displayed as rolling text.
Error message display
Please see the full manual for details.
1.
Switch function (open/closed) depends on setting at Mode 24.
7ML19985XA82
Downloaded from
www.Manualslib.com
input function block (0) selected
Falling Edge
(Switch Point 2)
0% Application
Range setting
parameter of the Discrete input function block; or the Primary Value of the Transducer
Block; or the Sensor Value discrete of the Transducer Block
backwards.
store the value.
Pointek CLS200/300 (Digital) – QUICK START MANUAL
manuals search engine
sensor covered
active
communications symbol
up arrow
(switch closed
)
1
Rising Edge
(Switch Point 1)
100% Application
Range setting
1
,
added indicator
(Mode 4)
mode
M
indicator
primary
reading
auxiliary
reading
Page EN-7
Werbung
Inhaltsverzeichnis
