Siemens Pointer CLS200 Schnellstartanleitung Seite 9

Quick Reference: operating functions using input keypad
Function,
Mode
(parameter in PDM)
2
Measured value display
Error display
Sensor test
Rise Time
Fall Time
10
HW Write Protection
13
Display Source
14
Unit
Node address (PROFIBUS
15
only)
16
PROFIBUS Ident Number
0% Application Range
19
setting
100% Application Range
20
setting
23
Alarm output trigger
24
Contact type
Switch Point 1
(Rising Edge) 25
OFF to ON
Switch Point 2
26
(Falling Edge)
ON to OFF
Local Status Text 27
1.
Press  to store numerical values; press M to store a selection (indicated by asterisk *).
2.
L appears in Mode indicator field if HW Write Protection is enabled.
3.
If L or LA appear after disabling HW Write Protection, local operation is locked via the bus. Use PDM to disable this lock.
Page EN-8 Pointek CLS200/300 (Digital) – QUICK START MANUAL
Downloaded from www.Manualslib.com
1

M
2 * Either key activates test
Open Edit mode, or Move cursor to right, or decrement digit, or
4
increment digit. store edited value.
Open Edit mode, or Move cursor to right, or decrement digit, or
5
increment digit. store edited value.
*
Either key enables Write Protection
* Increment or decrement value to make selection
* Increment or decrement value to make selection.
Open Edit mode, or Move cursor to the right, or decrement digit, or
increment digit. store edited value.
* Increment or decrement value to make selection.
1 
M
Open Edit mode, or Move cursor to the right, or decrement digit, or
increment digit.
Open Edit mode, or Move cursor to the right, or decrement digit, or
increment digit.
* Increment or decrement value to make selection.
* Increment or decrement value to make selection.
Open Edit mode, or Move cursor to the right, or decrement digit, or
increment digit.
Open Edit mode, or Move cursor to the right, or decrement digit, or
increment digit.
* Increment or decrement value to make selection.
manuals search engine
Key function
  and 
Hold for 5
2
seconds to
disable
  and 
store edited value.
store edited value.
store edited value.
store edited value.
Display/ explanation
Default startup display; or if Sensor selected in Mode 13
Error, if transmitter is disturbed
Displays GOOD or FAIL D
and value (seconds)
Range: 0.0 to 100.0 s
and value (seconds)
Range: 0.0 to 100.0 s
– – = disabled (parameter changes permitted)
L = enabled (parameter changes inhibited)
3
0 = OUT parameter; 1 = primary value;
2 = sensor; 3 = electronics temperature
o o o
Select C; F; R, or K (if 3 selected in Mode 13).
Assign slave address on the PROFIBUS-line (0 to 126)
Select device mode: according to profile; or, according to profile with full device
specific support.
Adjust lower limit of application range.
Adjust upper limit of application range.
Select diagnostic interrupt (dIAG); process interrupt (OUt_d); disabled (OFF): or
diagnostic alarm limit (set in PDM) exceeded (ALErt)
Set contact functionality in case of event: (logical inversion of alarm output switch)
- Make contact (CLOSE) / Break contact (OPEn)
Set % of range at which switch will change from OFF to ON. (Hysteresis is a
difference in value between Switch Point 1 and 2).
Set % of range at which switch will change from ON to OFF.
(Hysteresis is a difference in value between Switch Point 1 and 2).
Select presentation of the status text.
Pointek CLS200/300 (Digital) – QUICK START MANUAL 7ML19985XA02