Operating Instructions - TensCare Elise Handbuch

11.2. OPERATING
ON/OFF
5 seconds until the display shows.
To turn the unit off, press the ON/OFF
button and hold for 3 to 5 seconds until
the display stops.
When
automatically start in the programme
which was being used when it was last
switched off. The strength returns to
about 50% of the level that was being
used when the unit was switched off.
During start up to stop the increase in
strength at any time, press any key
once.
The unit will turn off automatically:
• When the Timer reaches zero,
• If it is left at zero strength for more
than 5 minutes.
STRENGTH CONTROLS
+
-
required strength is achieved.
To decrease the strength, press and
release the button -.
To increase strength in steps of 00.5
mA, press and release the button +.
The unit will remain in the WORK part
of the cycle for 5 seconds while
intensity is being adjusted.
Downloaded from www.Manualslib.com
INSTRUCTIONS
To turn the unit on, press the
ON/OFF button and hold for 3 to
switched on the
Note: Always check unit is
OFF before applying
removing probe or pads.
The buttons marked + and - are
the strength controls.
To increase strength, press and
hold down the button + until
manuals search engine
The strength levels are shown on the
LCD.
The strength control buttons will not
operate until the unit is properly
connected to you (probe inserted
correctly).
disconnection
returns the strength to zero.
unit will
The unit has levels of strength from 0 to
99.0 mA in steps of 00.5 mA. If you hold
down the button + for 3 to 5 seconds,
the strength will start scrolling.
You may feel nothing over the first few
presses. Continue pressing until the
sensation is strong but comfortable.
Further increases during use may be
necessary if your body becomes used
to the sensation.
PROGRAMME CONTROL
The button marked P is the
P
programme control. The Elise
or has four preset programmes. At first
use, the unit automatically goes to
programme STRES. Next time it is
switched on, it will default to the
programme used last.
Each time you press and release the P
button, the programme changes and is
shown on the LCD.
Each time you change the programme,
the strength level reverts back to zero.
This is a safety feature to alleviate any
sudden feeling of a surge, as each
programme gives a different sensation.
16
Elise detects a
and automatically