Low Battery - TensCare Elise Handbuch

TREATMENT TIMER
T
When you switch the unit on, it is
automatically set at 20 minutes.
To set a different time, set the strength
to zero and press T. The min display
will flash.
You can set session times of C
(Continuous) or 10, 20, 30, 45, 60 or 90
minutes with the buttons + and -.
Press T again to save your selection.
The LCD shows the session duration in
minutes. The unit automatically counts
down the minutes set and switches off
when it reaches 0.
If you hold down this key for 3 to 5
seconds, you can pause the timer,
allowing you to interrupt the treatment
session, and resume it later. Return to
main screen by pressing any other key.

LOW BATTERY

When the battery is running low, the
word BATT will show on the screen.
Although the display fades as the
batteries run down, the strength of the
output does not change until the
warning is shown.
LEADS ALARM
The Elise monitors the connection and
the contact between you and the probe,
or the pads. This is to prevent sudden
changes if a broken connection is re-
made. If either of these goes outside of
a standard range while the strength is
above 20.0 mA, the unit will flash
LEADS, bleep three times, and return
the strength to 00.0 mA.
Downloaded from www.Manualslib.com
The button marked T can be
used to set the session duration.
manuals search engine
Check the lead and if necessary,
lubricate the probe with a water based
lubricant such as TensCare Go Gel
(see K-GO). Please see section 19 for
more troubleshooting tips.
MEMORY
The Elise has a Memory with three
functions:
1) Programme Retention. When you
switch the unit on, it will automatically
start in the programme which was being
used when it was switched off.
2) To activate hold down the T and +
buttons together for 3 to 5 seconds. The
screen will show the time in hours (to
the nearest hour) and strength in mA.
Press the same buttons again to return
to normal controls.
3) Memory Reset. To reset memory to
zero, hold down the T and OFF buttons
together for 3 to 5 seconds.
17
Time in
hours
Average
strength