Operating Instructions - TensCare itouch sure Bedienungsanleitung

11.2. OPERATING
INSTRUCTIONS
ON/OFF
To turn the unit on, press the
ON/OFF button and hold for 3 to
5 seconds until the display
shows.
To turn the unit off, press the ON/OFF
button and hold for 3 to 5 seconds until
the display stops.
At first use, or after changing batteries,
the display shows that the unit is
automatically set in programme STRES
at zero strength.
When switched on
automatically start in the programme
which was being used when it was last
switched off.
During start up to stop the increase in
strength at any time, press any key
once.
The unit will turn off automatically:
• When the timer reaches zero,
• If it is left at zero strength for more
than 5 minutes.
Note: Always check unit is
OFF before
removing probe or pads.
The screen is illuminated whenever a
button is pressed.
STRENGTH CONTROLS
▲
The buttons marked ▲ and ▼
are the strength controls.
To increase strength, press
▼
and hold down the button ▲
the unit will
applying or
17
until required strength is achieved.
To decrease the strength, press and
release the button ▼.
To increase strength in steps of 0.5 mA,
press and release the button ▲.
The unit will remain in the WORK part
of the cycle for 5 seconds while
intensity is being adjusted.
The strength levels are shown on the
LCD.
The strength control buttons will not
operate until the unit is properly
connected to you (probe inserted
correctly). Itouch sure detects a
disconnection and
returns the strength to zero.
The unit has 198 levels of strength (0 to
99.5 mA). If you hold down the button
▲ for 3 to 5 seconds, the strength will
start scrolling.
You may feel nothing over the first few
presses. Continue pressing until the
sensation is strong but comfortable.
Further increases during use may be
necessary if your body becomes used
to the sensation.
PROGRAMME CONTROL
The button marked P is the
P
programme
itouch sure has four preset
programmes. At first use, the unit
automatically goes
STRES. Next time it is switched on, it
will default to the programme used last.
Each time you press and release the P
button, the programme changes and is
shown on the LCD.
Each time you change the programme,
the strength level reverts back to zero.
automatically
control. The
to programme