5. For your safety
5. For your safety
WARNING!
Select the appropriate pressure transducer with regard to scale range, performance and specific measure-
■
ment conditions prior to installing and starting the instrument.
Consider the relevant national regulations (e.g.: EN/IEC 60079-14) and observe the applicable standards
■
and directives for special applications (e.g. with dangerous media such as acetylene, flammable gases or
liquids and toxic gases or liquids and with compressors). Non-observance can result in serious injury and/or
damage to equipment.
Open pressure connections only after the system is without pressure!
■
Please make sure that the pressure transducer is only used within the overload threshold limit all the time!
■
Observe the ambient and working conditions outlined in chapter 7 "Initial start-up and operation".
■
WARNING!
Ensure that the pressure transducer is only operated in accordance with the provisions i.e. as described in
■
the following instructions.
Do not interfere with or change the pressure transducer in any other way than described in these operating
■
instructions.
Remove the pressure transducer from service and mark it to prevent it from being used again accidentally, if
■
it becomes damaged or unsafe for operation
Take precautions with regard to remaining media in removed pressure transducer. Remaining media in the
■
pressure port may be hazardous or toxic!
Have repairs performed by the manufacturer only.
■
The operator is responsible for the material compatibility as well as correct handling, operation and mainte-
■
nance.
Information about material consistency against corrosion and diffusion can be found in our WIKA-Handbook, 'Pressure and
Temperature Measurement'.
Operating instructions/Betriebsanleitung, WUD-2x
Downloaded from
www.Manualslib.com
manuals search engine
GB
5