Replacement Of The Pilot Light Injector; Equipment Decommissioning, Demolition And Disposal - Angelo Po 0N1CP1GH Bedienshandbuch

To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Disconnect the electricity supply.
2)
Open the hatch (A).
3)
Undo the screws to remove the drain lever
4)
(B).
Undo the screws to remove the panel
5)
GB

EQUIPMENT DECOMMISSIONING, DEMOLITION AND DISPOSAL

When decommissioning the appliance, a seri-
es of procedures must be carried out to ensure
that the appliance and its components are not a
hindrance and are not easily accessible.
To ensure that the appliance cannot constitu-
te hazards for people or the environment, all
energy sources (electricity, etc.) must be discon-
nected and rendered unusable, and any liquids
present must be drained (lubricants, fl uids, etc.).
Place the appliance in a suitable area which is
not easily accessible, with barriers to prevent an-
yone from accessing it.
3269830_inst_GB_rev.2

REPLACEMENT OF THE PILOT LIGHT INJECTOR

.
(C)
A
Unscrew fi tting (E).
6)
Remove the nozzle (D) and replace it with the
7)
one suitable for the type of gas in use (see
table at back of manual).
Replace all when the operation is complete.
8)
B
D
E
D
C
When scrapping, sort all components by chemi-
cal characteristics and dispose of them separa-
tely in accordance with the relevant legal requi-
rements.
Important
Do not dump non-biodegradable products,
lubricating oils, and non-metallic compo-
nents (rubber, PVC, resins, etc.) in the envi-
ronment. Dispose of them in compliance with
the relevant laws.
- 16 -
ENGLISH