cecotec CONGA WinDroid 970 Bedienungsanleitung Seite 32

Fan: Turn the robot over and wipe any debris from the fan with a cloth to maintain suction.
Guide wheels: Turn the robot over and wipe the four side rollers with a cloth to maintain their
effectiveness.
Driving treads: Before cleaning
the wheels, move the power
switch to the "-" position. Then
wait 8 seconds until it stops suc-
tioning and starts beeping. Then
press " " key on the remote
control and start cleaning the dri-
ving wheels.
Press Start/Pause and Clean bu-
ttons on the remote control to
check the driving wheels, if the-
re is any dust, press pause and
clean the dust.
After cleaning, turn off the
switch on of the bottom part to
the "O" position.
Conga WinDroid 970
32
Edge Detection Sensors: Turn over the robot and
wipe five edge detection sensors clean with a cloth
to maintain their effectiveness.
Squeegees: Turn over the robot and wipe the squee-
gee with a cloth to maintain their effectiveness.