Cleaning And Maintenance - Beko HNU51311SH Anleitung

4

Cleaning and Maintenance

CAUTION
Risk of damage due to the corro-
sion damage. Always operate the
appliance while cooking in order
to prevent condensate formation.
Condensate may cause corrosion
damage. Replace immediately the
faulty lamps in order to prevent ot-
her lamps from being overloaded.
The risk of damage occurs due
to the humidity intrusion to the
electronics. Never clean the cont-
A
rollers with a wet cloth. Surface
may be damaged due to improper
cleaning. Clean the stainless ste-
el surfaces only in the direction
of brushing. Do not use stainless
steel cleaner for controllers. The
surface may be damaged due
to abrasive or rubbing cleaning
agents. Never use abrasive or rub-
bing cleaning agents. There is the
risk of damage due to backflow
of condensate. Install the air out-
let duct with a slope of 1°, slightly
downwards the appliance.
CAUTION
A
You can use this appliance in was-
te air mode and in air circulation
mode.
Waste air mode
Absorbed air is cleaned by oil filters
and expelled by means of a piping
system. (Pic. 3) If you want to trans-
A
fer the waste air to a disabled smoke
or waste gas flue, you have to obta-
in permission from an authorised
flue cleaning specialist. If the waste
air is expelled over the external wall,
a telescopic wall frame should be
used.
14 / EN
C
Absorbed air is cleaned by oil fil-
ters and an active carbon filter and
retransferred to the kitchen. Pic. 4
NOTE!
The waste air should not be trans-
C
ferred to a smoke or waste gas
flue, nor to a flue used for venti-
lation of the places where heating
sources are installed.
To seal the materials causing odo-
ur in the circulating air mode, you
should install an active carbon fil-
ter. Consult your authorised dealer
C
to learn different opportunities
for operating the appliance in the
circulating air mode. You can buy
accessories necessary for this
procedure from relevant points of
sale, authorised service agents or
online sales centre.
The appliance you have purchased is suitable for
use with carbon filter. To attach the carbon filter;
1- Place the carbon filter into its housing. Pic. 15/1
2- Turn the carbon filter clockwise to make sure
that it is tightly inserted. Pic. 15/2
Res.13 Res.14
C
If the carbon filter is not properly at-
tached, it can fall and damage your
product.
CAUTION
A
Never wash the carbon filters.
Keep the carbon filters away from
children.
Res.15
Hood / User Manual