Cleaning And Maintenance; Replacing Lamps - Beko CFB 6311 XH Bedienungsanleitung

3

Cleaning and maintenance

Prior to cleaning and maintenance, unplug the
appliance or turn the main swich off or loosen the
fuse that supplies the hood.
Failure to comply with the provi-
sions relating to cleaning of the
device and replacement of filters
A
may cause fire risks. It is therefore
recommended to comply with the
guidelines given herein. The manu-
facturer is not liable for any dama-
ge to the engine or fires caused by
improper use.
Clean using only a cloth dampened with neutral
liquid detergent. Do not clean with tools or instru-
ments. Do not use abrasive products. Do not use
alcohol
3.1 Cleaning of Grease Filter
This filter captures oil particles in the air. You are
recommended to clean your filter every month
under normal usage conditions. First remove the
grease filters for this process. Wash the filters
with liquid detergent and rinse them with water
and install them back after they get dry. Grease
filters may get discolered as they are washed;
this is normal and you don't need to change your
filter.
C
You can wash the grease filter in
the dishwasher
3.2 Changing of Carbon Filter (Air
Circulation Mode)
The hood can be fitted with an active carbon filter.
The carbon filter is applied only in case the hood is
not connected to the vent duct.
In any case it is necessary to replace the carbon
filter at least every three months.
Hood / User Manual
A
WARNING
never washed.
A
WARNING
from Authorized Services.
3.3 Maintenance
ATTENTION! Before performing any maintenance
operation, isolate the hood from the electrical
supply by switching off at the connector and re-
moving the connector fuse. Or if the appliance has
been connected through a plug and socket, then
the plug must be removed from the socket.

3.4 Replacing Lamps

Disconnect the hood from the electricity.
A
WARNING: Prior to touching the
light bulbs ensure they are cooled
down.
Replace the damaged lamp. Use Ø35mm E14 28W
halogen candle lamps only
If you need to transport the
appliance
• Keep the original packaging of the appliance.
Transport the appliance with its original
package, and follow the transport markings
on the original package
If you do not have the original
package
• Do not place any objects on the hood.
• Protect the outer surface from impacts.
• Pack the appliance so that it would not be
damaged during transport.
:
The carbon filter is
:
Carbon filter is available
9 / EN