Operation - Flowair LEO EL Technische Dokumentation/Betriebsanleitung

5.1. OPERATION

Outlet air
temperature
Heating rods
Active (switch have to
Fan - thermostatic
Fan - continous
*At air inlet temperature 0
Room thermostat
1. Operation mode switch
2. ON/OFF switch
3. Temperature knob
The room thermostat should to be mounted at about 1.5m above the floor in a well ventilated place. Do not mount near heat
sources, lights, windows and doors. The thermostat is equipped with a 5 meters cable 7x1mm
same type.
It is prohibited to disconnect heater direct from power supply, Unit should be disconnect by switch
be disconnected after fan stops operating (approx. 2 min.)
SUMMER
ON
Same as room
temperature
3 heating rods active. Switched
OFF
off after reaching temperature
Active while rods on. After switching rods off, the fan continues to
o
be set to 30 C)
o
C
www.vent.prom.ua (044) 332-81-40, 331-37-81, +380 (63) 26247-62
HALF
(13,5kW)
ON
I
o
Δt* = +15
C
operate for 2 minutes to cool them down.
ON
FULL
(27kW)
ON
II
o
Δt* = +25
C
6 heating rods active. Switched
off after reaching temperature
2
. If a longer cable needed use the
OFF
ON → OFF
All
–
OFF
Active for 2
minutes
Active for 2
minutes
. Power supply can
| 9