Montage des Feldmikrofons
Das Array-Mikrofon wird direkt an einem Deckenraster montiert oder kann auf andere Weise befestigt werden.
Zunächst:
•
Die Kunststoff-Schutzabdeckung vom Mikrofon abnehmen.
•
Überprüfen, ob das Deckenraster der entsprechenden Modellvariante entspricht.
•
Sofern der optionale Verteiler verwendet wird, ist dieser vor der Deckenmontage am Mikrofon zu montieren.
WICHTIG: Das 60-cm-Modell darf nicht in einem 609,6-mm-Deckenraster montiert werden.
Modellvarianten
Modell
MXA910B
MXA910W
MXA910AL
MXA910B-60CM
MXA910W-60CM
MXA910AL-60CM
MXA910W-A
Rubber Scratch Protectors (All Models Except MXA910W-A)
Optional: Before installing the microphone in the ceiling, attach the included rubber pads on the corners of the microphone to
prevent scratching.
Ceiling Installation (All Models Except MXA910W-A)
1.
Make space in the ceiling grid for the array microphone to be installed.
2.
Run the Ethernet cable above the ceiling grid and through the opening in the ceiling.
Note: An optional junction box accessory (model A910-JB) mounts on the microphone to directly connect conduit.
3.
Plug the Ethernet cable into the array microphone output.
4.
Attach the safety tether between the building structure and one of the tie-off points on the back of the microphone using
braided metal cable or other highstrength wire (not included). This safety measure prevents the microphone from fal
ling in an emergency situation. Make sure there is no tension on the safety tether. Follow any local regulations.
Deckenrastergröße
60,9 x 60,9 cm
60,9 x 60,9 cm
60,9 x 60,9 cm
60 cm x 60 cm
60 cm x 60 cm
60 cm x 60 cm
60,9 x 60,9 cm
Farbe
Schwarz
Weiß
Aluminium
Schwarz
Weiß
Aluminium
Weiß
Shure Incorporated
24/63