What To Do If - Electrolux EOC69900 Benutzerinformation

20 electrolux
2. Pull the rear shelf support rail away from
the side wall and remove it.

WHAT TO DO IF...

Warning! Refer to "Safety information"
chapter.
Problem
The appliance does not
heat up.
The display shows error
message "F....."
The oven lamp does not
operate.
Steam and condensation
settle on the food and in
the appliance.
If you cannot find a solution to the problem
yourself, contact your dealer or the service
centre.
We recommend that you write the data here:
Downloaded from www.Manualslib.com
Possible cause
The appliance is deactivated.
The necessary settings are not set . Do a check of the settings .
The Child lock is on.
The fuse in the fuse box is released. Do a check of the fuse.
Electronic error.
The oven lamp is defective.
You left the dish in the appliance
for too long .
manuals search engine
Installing the shelf support rails
Install the shelf support rails in opposite se-
quence.
The rounded ends of the shelf support
rails must point to the front!
Oven lamp
Warning! Be careful! There is the risk
of electrical shock!
Before you change the oven lamp:
• Switch off the oven.
• Remove the fuses in the fuse box or
switch off the circuit breaker.
Put a cloth on the bottom of the oven
for protection of the oven light and
glass cover.
1. Turn the glass cover anti-clockwise to re-
move it.
2. Clean the glass cover.
3. Replace the oven light bulb with applica-
ble 300°C heat-resistant oven light bulb.
Use the same oven lamp type.
4. Install the glass cover.
Activate the appliance.
Refer to "Deactivating the Child
lock".
If the fuse is released more than
one time, contact a qualified elec-
trician .
Contact Service Center.
Refer to "Replace the oven lamp".
Do not leave the dishes in the ap-
pliance for longer than 15-20 mi-
nutes after the cooking ends.
The necessary data for the service centre is
on the rating plate. The rating plate is on
the front frame of the oven cavity.
Remedy