Error Codes - Cebora PLASMA PROF 164 HQC Bedienungsanleitung

®

4.7 Error codes

Start pressed when the machine is switched on
Overtemperature: power circuit (IGBT module)
Waiting final value coolant flow (at the start of power source)
Problem with wiring of cooling circuit
Pressure low in the gas inlet
Door open in the power source or HV18 module
CNC not connected to the power source
CNC in Emergency or off
Internal error on microprocessor memory
The power source is not communicating with the gas console
The gas console is not communicating with the power source
LEM of pilot arc circuit out of scale
Dangerous voltage: power circuit failure
Current during cutting in pilot arc circuit
Torch protection absence
Torch not recognized at start-up
Electrode finished
Liquid coolant flow insufficient
Purge not finished or
pressure high in gas inlet
Gas console not connected to power source
Gas console PGC-1 and PGC-2 not connected between them
Error description
3300945-A
73
Display
TRG
TH1
H2O
H2O nc
GAS LO
OPN
rob int
rob
Err 2
Err 6
Err 9
Err 39
Err 40
Err 49
Err 50
Err 51
Err 55
Err 75
Err 79
Err 81
Err 82