Ottobock 50S3 Malleo Sprint Gebrauchsanweisung Seite 11

► Before each use, check the product for functional reliability and for
possible wear or damage.
► Do not continue using a product that is no longer functional, or that is
worn or damaged.
NOTICE
Improper use and changes
Change in or loss of functionality as well as damage to the product
► Use this product with care and only for its intended purpose.
► Do not make any improper changes to the product.
The orthosis is delivered ready for trial fitting. Adjustment is not required.
> The strap on the orthosis is open and the fasteners are loosened.
1) Pull the orthosis over your foot (see fig. 1) and tie it like a normal shoe
(see fig. 2).
Optional: Use the quick fasteners (see fig. 3).
2) Pass the outer end of the strap over the instep and pull it under the foot
from the inner (medial) side.
3) Fasten the outer end of the strap over the ankle on the outer (lateral)
side (see fig. 4).
4) Pass the inner end of the strap over the instep and pull it under the foot
from the outer (lateral) side.
5) Fasten the inner end of the strap over the ankle on the inner (medial)
side (see fig. 5).
6) If the physician has allowed weight-bearing on the foot:
Loosen the ends of the strap and re-tighten (see fig. 6).
4.3 Cleaning
1) Close all hook-and-loop closures.
2) Hand wash the orthosis in warm water at 40°C with mild laundry deter­
gent.
3) Rinse well.
4) Allow to air dry. Do not expose to direct heat sources (e.g. sunlight,
stove or radiator).
5 Disposal
Dispose of the product in accordance with national regulations.
11