Automatic Operation; Manual Operation - attika PILAR Installationsanleitung

USE OF WOOD-BURNING STOVE WITH ELECTRONICAIR
After the remote control is synchronised and set, the wood-burning stove can be used. The wood-burning stove can be used with
automatic or manual operation.

AUTOMATIC OPERATION

If you want the damper on the wood-burning stove to be regulated automatically, you can use the remote control to set the stove
to automatic operation. Follow this guide showing how to operate a wood-burning stove with ElectronicAIR that is in automatic
operation mode.
1. First, you must ensure that the wood-burning stove has been set to automatic operation. To switch to automatic operation,
briefly press the 'up' button and 'down' button at the same time. "Auto" is shown in the display.
2. Light the fire in the wood-burning stove. If required, read the section "Starting the fire correctly" in the user manual.
3. Let the door stay slightly open for approximately five minutes. Next, close the door.
4. Once there is a good layer of embers, place two logs on the fire.
5. ElectronicAIR regulates the actual combustion air during burning.

MANUAL OPERATION

If you wish to personally regulate the wood-burning stove, you can use the remote control to set the stove to manual operation.
Follow this guide showing how to operate a wood-burning stove with ElectronicAIR that is in manual operation mode.
1. First, you must ensure that the wood-burning stove has been set to manual operation. To switch to manual operation, briefly
press the 'up' button and 'down' button at the same time. "Manual" is shown in the display.
2. Light the fire in the wood-burning stove. If required, read the section "Starting the fire correctly" in the user manual.
3. Let the door stay slightly open for approximately five minutes. Next, close the door.
4. Once there is a good layer of embers, place two logs on the fire.
5. Open and close the damper by using the two arrows on the remote control.
NB! The LED light on the front of the wood-burning stove lights green when you open and close the
door and the damper automatically regulates up or down. In addition, the LED light lights briefly
when you press the buttons on the remote control.
If the LED light lights red or yellow, then please refer to the troubleshooting section below .
GB - 25