Zodiac Ei2 Montage- Und Gebrauchsanleitung Seite 27

• Press the butt on. The polarity inversion cycle hours start to fl ash.
• Use the and
• Press the butt on to return to the home screen.
3.2.6.c Operati ng hours counter
Ei² Expert can count its total operati ng hours (= chlorine producti on ti me, affi ché en jours). This informati on
may be useful to determine the electrode age. The value is provided for informati on only and may be modifi ed.
• From the home screen, press the
• The number of operati ng hours is displayed at the bott om right of the screen.
• Press the butt on to return to the home screen.
4. Maintenance
4.1 Washing the pool fi lter (backwash)
L'appareil doit impérati vement être éteint lors des procédures de lavage de fi ltre. When the device is on
(fi ltrati on on), press the
Aft er cleaning the fi lter, switch the device on again by pressing the
normal operati on (producti on slaved to fi ltrati on for Ei² and GenSalt OE.
Pour Ei² Expert la producti on foncti onnera selon le réglage des ti mers.
The manufacturer cannot be held liable in case of incorrect handling.
4.2 Cleaning the electrode
The electrolyser is equipped with a smart polarity inversion system designed to prevent the electrode plates from
scaling. However cleaning may be required in regions where the water is very hard. (default setti ng = 5 hours).
• Turn off the chlorinator and the fi ltering, close the isolati on valves, remove the protecti on cover and disconnect the cell
power cable.
• Unscrew the ti ghtening ring and remove the cell. The ring is notched thus allowing a lever to be used in the event of it
jamming. Place the cell backwards and fi ll it with a cleaning soluti on so that the electrode plates are immersed.
• Leave the cleaning soluti on to dissolve the scale deposit for about 15 minutes. Dispose of the cleaning soluti on at an
approved waste recycling site, never pour into the rainwater drainage system or into the sewers.
• Rinse the electrode using clean water and put it back on the cell fi xture collar (there is an alignment foolproofer).
butt ons to select the required cycle.
and
butt on for 5 seconds to switch it off .
butt ons for 5 seconds.
butt on (short press). It will resume
EN
12