Zodiac Ei2 Montage- Und Gebrauchsanleitung Seite 23

3.2 Descripti on of the Ei² Expert user interface
If the language displayed on the screen when the Ei² Expert is fi rst switched on is not appropriate, see "3.2.6
"Internal setti ngs" menu".
3.2.1 Chlorine producti on acti vated
When chlorine producti on starts, the "Start..." message is displayed on screen for about 6 seconds. "CHLORINATION" is
then displayed, indicati ng that the device is producing chlorine.
3.2.2 "Boost" mode: chlorine producti on increased to 100 % for 24 h
In certain cases the pool may need higher than normal chlorinati on (stormy weather, high number of bathers, etc.).
"Boost" mode is used to increase chlorine level quickly.
• Press butt ons and
starts.
• To stop "Boost" mode, press
When "Boost" mode is acti vated, the rated chlorine producti on setti ngs are temporarily overridden and the Ei²
Expert chlorinator will operate for a total of 24 hours at 100 % chlorine producti on. The number of days will
therefore depend on the Ei² Expert operati ng ti mes (see "").
3.2.3 "Low" mode: chlorine producti on reduced to 10 % if the pool is covered
Increase or reducti on the chlorine producti on:
- Acti vate / deacti vate the chlorine producti on by a short press.
- Switch off the device with a long press (5 seconds).
- Switch on the device with a short press.
FLOW Red indicator showing the absence of fl ow and/or presence of air in the cell.
Orange indicator showing a water conducti vity problem (not enough salt,
SALT
water too cold, etc.).
- Exit the user menu or the internal setti ngs menu.
- Deacti vate Boost mode or Low mode.
- From the home screen: increase or decrease in chlorine producti on.
- In the user menu: value changes when a choice is proposed (fl ashing
characters).
- Simultaneous press for 5 seconds: access the internal setti ngs menu.
- Access to user menu and navigati on in the setti ngs (with successive
presses)
- Acti vate/deacti vate the chlorine producti on by a short press.
- Switch off the device with a long press
- Switch on the device with a short press
- Acti vate Boost mode
and
- Acti vate "Low" mode manually
and
simultaneously: "BOOST" is displayed on the screen and 100 % chlorine producti on
.
20 % 100 %
40 %
60 % 80 %
EN
8