Unpacking; Names And Functions Of Parts - Samsung SMT-171N Benutzerhandbuch

SMT-171/SMT-190-ENG 12/8/05
USER'S MANUAL

Unpacking

Remove the package cover and place the product on a flat and
secure surface or in the installation location.
Check whether all the following devices and accessories are
included with the main system.
E
TFT-LCD MONITOR
AC POWER ADAPTOR BATTERIES

Names and Functions of Parts

Front Key Control
1 2
1. SOURCE /
Select input source, and move the previous menu.
2. MENU
Activates and exits the On Screen Display.
OSD MENU(MAIN) : Input, Picture, OSD, Setup.
3. AUTO / (DOWN)
This button is move the OSD menu, and use to auto
adjustment of VGA input only.
4. (UP)
Move the OSD main menu or sub menu.
5. (LEFT)
This button is decrease the level of active function, and
move the previous menu.
6. (RIGHT)
This button is increase the level of active function, and
select OSD menu.
7. IR Sensor
Remote controller sensor.
8. POWER ON/OFF
Turns the power ON or OFF. There will be a few
seconds delay before the display appears.
The power LED(next to the power switch) lights with
9:40 AM Page 6
USER'S MANUAL POWER CORD
REMOTE CONTROLLER VGA SIGNAL CABLE
3 4 5 6 7
green when the power is turned ON.
The power is turned off by pressing the power switch
again and the power LED goes off.
Bottom Panel Control
8 7
1. DC 12V IN
DC power Input.
2. VGA IN
VGA Signal Input.
3. VIDEO A IN
Composite signal Input for VIDEO A
4. VIDEO A OUT
Video looping output for VIDEO A
5. VIDEO B IN
Composite signal Input for VIDEO B
6. VIDEO B OUT
8
Video looping output for VIDEO B
7. S-VIDEO (Y/C) IN
Y/C separated signal input
8. S-VIDEO (Y/C) OUT
Y/C separated signal looping output
- 6 -
6 5 4 3
2 1