Operating The Appliance; Using The Touch Controls; Switching On; Power Mode - Caso Comfort C2000 Originalbetriebsanleitung

► Switch the appliance off after use. This avoids unnecessary use of energy, and ensures
your safety.
► If the appliance is unused for extended periods of time, we recommend that the appliance
be unplugged from the mains.

15.4 Operating the Appliance

15.4.1

Using the Touch Controls

15.4.2

Switching On

• Plug the power plug into a suitable outlet.
• The temperature of the cooker plate surface displayed: is the temperature of the surface
of the induction cooker lower than 50°C, the display shows „L". When the temperature of
the cooker plate surface is over 50 °C, it is displaying „H". An acoustic signal sounds.
Now the device is in standby mode.
• Place a suitable cooking pot with its contents on the centre on the hob (Ø 150 mm - 220
mm).
• Press the ON/Standby button once. When you have done that an acoustic signal
sounds.
► If no further input occurs within 10 seconds of the device switching on, the device will
switch off.
15.4.3

Power Mode

• Chose power mode with function button (6), then you can see 1600 in the display.
• With the +/- buttons you can choose between 10 levels (120, 300, 500, 800, 1000, 1200,
1400, 1600, 1800, 2000 watt). The choosed power is shown in the display.
15.4.4

Temperature Mode

• Chose temperature mode with function button (6), then you can see 140 in the display.
• With the +/- buttons you can choose between the temperature levels which will then be
shown in the display. You can set temperatures between 60°C and 200°C (60, 80, 100,
120, 140, 160, 170, 180, 190, 200).
caso Comfort C2000
The controls respond to touch, so you don't need to apply any
pressure. Use the ball of your finger, not its tip.
You will hear a beep each time a touch is registered.
Make sure the controls are always clean, dry, and that there is
no object (e.g. a utensil or a cloth) covering them. Even a thin
film of water may make the controls difficult to operate.
Please note
42