Turn Off Gas To Appliance - Maxitrol GV60 Installations- Und Bedienungsanleitung

OPERATING INSTRUCTIONS
TO TURN ON APPLIANCE
When pilot ignition is confi rmed, motor turns automatically
to maximum fl ame height.
▪ Turn MANUAL knob on valve to the ON, full counter-clock-
wise position (see fi gure 27, page 19).
▪ Place ON/OFF switch (if equipped) in I (ON position).
Handset
▪ Simultaneously press the OFF and
fl ame) buttons until a short beep confi rms
the start sequence has begun; release but-
tons.
▪ Continuing beeps confi rm the ignition is in
process.
▪ Once pilot ignition is confi rmed, there is
main gas fl ow.
▪ After main burner ignition the handset will
automatically go into manual mode (CSA
version, CE version).
Wall Switch / Touchpad / Switch Panel
▪ Press button "B" (see fi gure 25) until a short beep confi rms
the start sequence has begun; release button.
▪ Continuing beeps confi rm the ignition is in process.
▪ Once pilot ignition is confi rmed, there is main gas fl ow.
If the pilot does not stay lit after several tries, turn the main
valve knob to OFF and follow the instructions "TURN OFF
GAS TO APPLIANCE" (page 19).
STANDBY MODE (Pilot Flame)
Handset
▪ Press and hold (small fl ame) to set appliance at pilot fl ame.
Wall Switch / Touchpad / Switch Panel
▪ Press and hold button "C" (see fi gure 25) to set appliance
at pilot fl ame.
A) Increase fl ame height
B) ON/OFF
C) Decrease fl ame height
Figure 25: Switch Panel and Wall Switch/Touchpad
TO TURN OFF APPLIANCE
FLAME HEIGHT ADJUSTMENT
(large
Handset
Wall Switch/Touchpad/Switch Panel (see fi gure 25)
▪ Press and hold button "A" to increase fl ame height.
▪ Press and hold button "C" to decrease fl ame height or to
set appliance at pilot fl ame.
▪ For fi ne adjustment tap button "A" or "C".
Designated Low Fire and High Fire
C
MAN
C
MAN
If the appliance will not operate, follow the instructions
"TURN OFF GAS TO APPLIANCE" (page 19).
15 / 20
FOR OEM USE ONLY
Handset
▪ Press OFF button.
Wall Switch / Touchpad / Switch Panel
▪ Press button "B" (see fi gure 25).
▪ In standby mode: Press and hold
fl ame) button to increase fl ame height.
▪ Press and hold (small fl ame) button to de-
crease fl ame height or to set appliance at
pilot fl ame.
▪ For fi ne adjustment tap the
or (small fl ame) buttons.
▪ Double-click (small fl ame) button. "LO"
will be displayed.
NOTE: Flame goes to high fi re fi rst before
going to designated low fi re.
▪ Double-click (large fl ame) button. Flame
automatically goes to high fi re. "HI" will be
displayed.
(large
(large fl ame)