Operating Instructions; General Notes; Setting The Electronic Code; Light/Dimmer Operation - Maxitrol GV60 Installations- Und Bedienungsanleitung

OPERATING INSTRUCTIONS

Temperature
ON/OFF Temperatures setting
Program timer setting
Fan operation

Modes of operation

Figure 22: Handset display

GENERAL NOTES

Radio Frequency Handset
433.92 MHz for Europe; 315 MHz for U.S. and for Canada..
This device complies with part 15 of the FCC Rules. Op-
eration is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This
device must accept any interference received, including in-
terference that may cause undesired operation. Changes or
modifications not expressly approved by the party respon-
sible for compliance could void the user's authority to oper-
ate the equipment.
NOTICE
Wiring of valve and receiver must be completed before
starting ignition. Failure to do so could damage the elec-
tronics.
Batteries – Handset
▪ 1 x 9 V (alkaline recommended).
▪ Low battery indicator on handsets with display.
▪ Handsets without display: the red LED gets darker.
▪ Battery replacement is recommended after 2 years.
Batteries – Receiver
▪ 4 x 1.5 V "AA" (alkaline recommended).
▪ Low battery indication: frequent beeps for 3 seconds when
motor turns.
▪ An AC Mains Adapter may be used instead of batteries.
▪ The module for fan speed control and light/dimmer in-
cludes mains power together with batteries in the receiver
for automatic backup in case of power outage.
▪ Without using a mains adapter, battery replacement is rec-
ommended at the beginning of each heating season.
NOTICE
Only the Mertik Maxitrol AC Mains Adapter or one
preapproved by Mertik Maxitrol can be used. Use of other
adaptors can render the system inoperable.
NOTICE
The handsets, receivers, wall switches, switch panels and
touchpads are not interchangeable with previous electron-
ics (see figure 24).
°C/24 hour or °F/12 hour Clock setting
NOTICE
Replacement handsets for CSA models also must have
the same part number (see label).
SETTING THE ELECTRONICS CODE
(First time use only.)
Radio Frequency Handset
A code is selected automatically for all Mertik Maxitrol elec-
tronics from among 65,000 random codes available. The re-
ceiver has to learn the code of the handset:
▪ Press and hold the receiver's reset button (see figure 24)
until you hear two (2) beeps. The first beep is short and the
second beep is long. After the second beep, release the
reset button.
▪ Within the subsequent 20 seconds press the
flame) button on the handset until you hear two additional
short beeps confirming the code is set. If you hear one long
beep, this indicates the code learning sequence has failed
or the wiring is incorrect.
NOTE: This is a one time setting only, and is not required
after changing the batteries of the handset or re-
ceiver.
Figure 24: Receiver Reset Button
14 / 20
FOR OEM USE ONLY
Signal indicator
Battery status
Time setting

Light/Dimmer operation

Solenoid Valve/Burner
OPEN and CLOSE
Fan level icon
Figure 23: Previous handset
(small