Connecting The Cg-1 Gyro - Carson CG-1 micro Betriebsanleitung

8. Connecting the CG-1 Gyro

Connect the gyro with a 3-pin connection cable (1) to the receiver
output for the tail servo.
The connections are:
Brown = minus
Red = plus
Orange = pulse
Connect the 1-pin normal input (yellow) of the gyro (2) with a free
channel which is controlled on the sender with a sliding controller.
What connections on the receiver have to be exactly assigned
depends on the remote control manufacturer and can be read up
in the documents of the system used.
The tail rotor servo (11) is connected directly to the gyro. Ensure
correct polarity of the servo socket (14). The pulse line (15) of the
servo cable (depending on servo manufacturer yellow, white or
orange) must point upwards.
2
CARSON Gyro 507027
15
11
14
13
GB