Carson CG-1 micro Betriebsanleitung Seite 16

Depending on the control direction on the sensor, the sensitivity
GB
of the gyro is increased in normal or in heading lock mode. The
respective end position of the sliding controller (0% or 100%
sensor route) corresponds always to a maximum gyro sensitivity.
For a sensor position of 0-50%, the gyro works in normal mode
and for a sensor position of 50-100%, the gyro works in "heading
lock" mode.
Instead of a sliding controller, a toggle switch can also be used
for switching the operating mode. In this case the required setting
values must be programmed in the ATV menu (route settings of
the control sensor). In conjunction with a flight condition swit-
ching, an individual gyro sensitivity can thus be programmed for
hovering flight, sightseeing flight and artistic flight.
In order to to check whether the gyro works in the correct mode
for the respective sensor settings, first launch the sender. Then
switch on the receiver with gyro and connected servo. The sliding
controller should be set so that the gyro works at about 75% of
sensitivity in "normal mode". The sensor route is then at approx.
12.5%.
16
100%
50%
0%
CARSON Gyro 507027
100%
50%
0%
100%
50%
0%
50%
100%