Installation Of The Cg-1 Gyro-System - Carson CG-1 micro Betriebsanleitung

Attention important!
GB
Do not launch your gyro, until you have read the following
sections in full and know what must be observed during
installation and operation. This is the only way to prevent
malfunctions or even damage.
The gyro is connected to the receiving output (1) for the tail servo.
The tail servo itself is connected to the gyro system (3) (picture
page 9).
This means that the gyro is switched between the receiver and
the tail servo.
In addition, the gyro is connected to another receiver output
"GAIN" (2) via which the sensitivity regulation is later carried out.
6. Installation of the CG-1 Gyro system
When installing the gyro, ensure that you select a place of instal-
lation where the gyro is well protected from vibrations and heat
fluctuations (picture page 11).
In most of the cases the manufacturers of the respective model
set the exact place of installation for the gyro.
If this is not the case on your model, select a place of installation
which is close to the main rotor shaft (7).
The installation platform (8) where you fit the gyro must be in a 90
degrees angle toi the main rotor shaft.
Use the supplied, two-side adhesive foam pad (9) for fitting only.
The stabilisation axle (10) of the gyro runs in parallel to the main
rotor shaft.
10
CARSON Gyro 507027