3M 6000 serie Handbuch Seite 167

or Reference Leaflet). This may not be the level of
o respiratory protection that can be realistically
expected in the workplace by wearers.
3M™ 6000 Series Fullface
nt.
Mask with
P1 Particulate Filters
P2 Particulate Filters
P3 Particulate Filters
g
Class 1 Gas & Vapour Filters
Class 2 Gas & Vapour Filters
e
d,
m
3M™Air Supply Unit
Required Minimum Protection Factor (RMPF) - the
protection factor required to reduce exposure to an
acceptable level. It is expressed as a ratio of the
measured ambient airborne concentration of a
contamniant to an acceptable exposure level or
stanard.
Many countries apply Assigned Protection Factors
ay
(APFs). For P3 rated filters: Provides P3 protection
only with a full facepiece respirator. Provides P2
protection with half facepiece respirator. Employers
may apply a value lower than the APF if deemed
applicable.
Please refer to AS/NZS1715 for application of these
V.
numbers in the workplace. Please contact 3M for
e
further information.
I
Eye Protection Meets the requirements of EN166
(Increased Robustness, Protection against High
Speed Particles (medium energy) and Lateral
protection. Meets high impact rating and protection
against hot solids to AS/NZS1337.
Flow Characteristics
Manufacturers Minimum Design Flow (MMDF) 150
l/min
Maximum Flow - See appropriate User Instructions.
Maximum Operating Temperature: +49 °C.
CAUTION Care should be taken when using the
equipment at low temperatures as excessive
moisture may cause the valves to freeze.
e
Nominal Protection Factor
5 x TLV
15 x TLV
1000 x TLV
2000 x TLV or 1000ppm
(Whichever is lower)
2000 x TLV or 5000ppm
(Whichever is lower)
SeeAirline user instruction
166