3M 6000 serie Handbuch Seite 10

TECHNICAL SPECIFICATION
or
o
Respiratory Protection EN136 (Class 1) - for use
with 3M Filters (bayonet) to EN14387:2004 or
EN143:2000 (see Reference Leaflet).
nt.
3M™ 6000 Series Fullface
Mask with
P1 Particulate Filters
P2 Particulate Filters
g
P3 Particulate Filters
Class 1 Gas & Vapour Filters
e
Class 2 Gas & Vapour Filters
3M™Air Supply Unit
*Assigned Protection Factors (APF) are taken from
HSE publications.
Please refer to EN 529:2005 and National
workplace protection guidance for application of
these numbers in the workplace.
Please contact 3M for further information.
s
Eye Protection Meets the requirements of EN166
(Increased Robustness, Protection against High
Speed Particles (medium energy, grade B) and
lateral protection.)
ay
Flow Characteristics
Manufacturers Minimum Design Flow (MMDF) 150
l/min
Maximum Flow - See appropriate User Instructions.
Maximum Operating Temperature: +49 °C.
CAUTION Care should be taken when using the
V.
equipment at low temperatures as excessive
e
moisture may cause the valves to freeze.
I
APF* 3M™ Full Face mask
4
10
20
20 or 1000ppm (0.1% vol)
whichever is lower
20 or 5000ppm (0.5% vol)
whichever is lower
SeeAirline user instruction
9